This is a 3D printed mold for people who make their own bath bombs and is designed to be used by hand.  
 
The mold is available as a 1 piece multi-mold, with the option to purchase a compactor piece to help you compact your mix into the mold. Colour of mold may vary from photos.
 
Approximate final bath bomb size: 2.5 cm wide x 2.5 cm tall x 1 cm deep (1" wide x 1" tall x 0.5" deep).
 
Bath bombs in photos weigh approximately 6 grams / 0.2 oz. (Bath bomb not included.)
 
Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane.  To clean your mold, rinse under cool water and towel dry.  PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.
 
Molds are printed to order, so we do not offer refunds or cancellations on any orders. If you have any issues with any item, please contact us directly, and we will work with you. If you have any quality issues, please contact us directly.
 
To use:  Place bath bomb mix into mold. Scrape off excess mixture so that the mix is flat (and will be flat when unmolded). If you are using the compactor piece, place the compactor piece on top and press down to more tightly compact your mix. Remove compactor piece (if applicable), tap the mold with your "tapping spoon" (a spoon or other utensil), then flip mold onto a hard surface (e.g. baking sheet) and lift mold off of bath bombs. If the mold does not lift off, tap the mold with your "tapping spoon" to tap the bath bombs out of the mold.