This is a 3D printed mold for people who make their own bath bombs and is designed to be used by hand.
The mold contains 1 piece and is available as a single mold to make one bath bomb at a time, or a multi-mini, to make 4 bath bombs at a time. Colour of mold may vary from photos.
Approximate final bath bomb size: 3.5 cm diameter x 2 cm deep (1.5" diameter x 0.75" deep).
Bath bombs in photos weigh approximately 20 grams / 0.7 oz. (Bath bomb not included.)
Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane. To clean your mold, rinse under cool water and towel dry. PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.
Molds are printed to order, so we do not offer refunds or cancellations on any orders. If you have any issues with any item, please contact us directly, and we will work with you. If you have any quality issues, please contact us directly.
To use: Place bath bomb mix into mold. Scrape off excess mixture so that the mix is flat (and will be flat when unmolded). Flip mold onto a hard surface (e.g. baking sheet) and lift mold off of bath bomb. If the mold does not lift off, tap the mold with a spoon or other utensil to tap the bath bomb out of the mold.
Mini Snowflake Bath Bomb Mold
This is for a mold only - bath bomb is not included.
Reviews
Sweet snowflake, perfect size and quality multi-mold!
I looked at many snowflake molds but did not like the design of most. My only mistake in purchasing this was I bought the single and not multi. Hand pressing hundreds of single snowflakes takes a very long time. They always come out clean and very easy to use, but buy the Multi!!!